Subaru Security Light Flashing Car Wont Start

Blink 2015 outback i have the manuel.

Subaru security light flashing car wont start.

The security light is going to be flashing. The security light on your vehicle serves has two purposes. Its other main purpose is to indicate that the security of your vehicle may have been compromised and the engine has been immobilized to prevent potential theft. Repeat these steps for a total for 3 10 minute cycles.

Only one key will start the car though whereas both worked fine before. Insert the ignition key and turn it to the on position and then attempt to start the engine crank over the engine wont start. It could be dead or low and needs charging. Turn the key off and wait 5 seconds.

With the key still in the run position wait 10 minutes and the security light should blink and then go out. It could be dead or low and needs charging. The second key now causes the security light to glow red when i insert the key in the ignition. My car won t start.

Leave it for ten minutes like that until the security light turns solid not blinking. I reprogrammed the key and got all the beeps and light blinks when expected. In that case the car s system won t be able to read the security code off the key fob. Holding unlock answered by a verified subaru mechanic.

What can i do. Y olsdmobile lss 98 is on security light flashing and won t star how to fixed put key in ignition and turn all the way like your e going to start it but don t start it.